Graham Anvil – 117 Lbs 4150 steel
Named after Graham, Atlas’ big brother, this is everything I could think to put in an anvil.
Comes with a 3/4″ hot cut hardy
Cast AISI 4150 steel
Medium frequency induction heated for a surface hardening to 6mm
Round and Square swages
86% of total mass is under the face (optimal for knifemaking)
Target weight of 117 lbs
9″ x 4″ face
5″ Conical short horn
1″ step
1″ Hardy
1/2″ pritchel
These anvils will ONLY be shipped via UPS Ground
New anvils will require dressing. This is the process of grinding your anvil smooth to your liking. An angle grinder with a 40/80/120 flap wheel will only take a few minutes to dress the horn, corners, step, etc. Some use the anvil as/is, others want to polish it before using. The choice is entirely up to you.
The face and bottom of the anvil have been machined flat. These surfaces are ready to use.
The horn and step have been lightly ground, to inspect for any defects.
Some of these anvils may have very fine surface cracks. We believe this is caused by the surface grinding being too aggressive. We have tested these thoroughly and found that they are very shallow and DO NOT AFFECT PERFORMANCE.
